PCB Board SMT Cleaning Machine

WASHMAC PCB board water cleaning system is a cleaning machine that does not require peripheral water treatment equipment. It is fully automatic, full-process, intelligent cleaning, unattended, and simple to set up. It meets European and domestic emission standards. It is used in pure water-based cleaning equipment at home and abroad. At the cutting edge level.

WASHMAC PCB board water cleaning system is a fully automated cleaning system that cleans the flux residues formed after the surface assembly board welding and the contaminants generated during the assembly process. It can effectively remove residual organic and inorganic contaminants such as rosin (R, RA, RMA), water-soluble flux (OA), no-clean flux and lead-free solder paste on the surface of SMT/THT and PCB boards. It is to achieve some high-reliability products before the three-prevention treatment and the three types of high-performance electronic products described in IPC-A-610, including the cleaning requirements of equipment and products that run continuously or operate strictly in accordance with instructions. It is economical and cost-effective. Cleaning equipment. At the same time, it is also a new type of water-based cleaning equipment that replaces the application of ODS material cleaning technology.

The system has a built-in high-purity deionized water generation system, and the purity of the generated deionized water can reach 18MΩ±0.2; the amount of solvent used can be adjusted according to different residual flux settings, so as to achieve the purpose of water-based cleaning and make the cleaned products have Guarantee, lower operating cost;

Features:

Zero peripheral auxiliary equipment, quickly connect the upper and lower water sources;

Built-in high-purity water treatment system to ensure the cleanliness of the PCB board after cleaning;

Carbon steel spray structure;

Fully automatic, full process, intelligent cleaning;

Simple setting, unattended;

Large size operation observation window, W570mm X H370mm;

Open and closed loop dual-mode cleaning;

Simple programming, automatic completion of all cleaning procedures of cleaning, rinsing and drying;

The cleaning and flushing pressure can reach 5kg;

Cleanliness monitoring system, conductivity control range 10μs～200μs;

Large capacity cleaning room (800 mm X800 mm X880mm);

Centrifugal spray method for cleaning and rinsing;

All stainless steel upper, middle and lower three-layer spray arms, spray and wash evenly;

The use of replaceable stainless steel nozzles facilitates process adjustment and maintenance;

The middle layer uses stainless steel rotating nozzles to ensure that there are no dead corners and shadows in the cleaning;

The use of external isolation inertial heating method reduces power consumption, and the temperature rises faster, the deionized water will not be ionized, and the cleaning quality is ensured.

It can clean rosin flux, no-clean flux, and water-soluble flux.

The double-layer cleaning blue with pulleys is convenient for loading and unloading.

Three PCB board placement methods: inclined, straight slot, hanging cage; suitable for various types of PCB boards.

Built-in solvent filling system and cleaning fluid heat preservation and heating system. The cleaning agent can be added manually or automatically inhaled according to the set ratio.

The entire cleaning process can be completed automatically according to the set program, and different cleaning time and temperature can be input for different size PCBs. Rinsing time, temperature and number of rinsing, hot air drying temperature and level.

Intelligent microcomputer control, simple operation interface, large-size LCD real-time display of working status, limit state alarm, automatic display of the cause of failure;

Water source inlet pressure protection, to prevent the equipment from continuing to operate after the tap water is stopped, and to protect the high-pressure pump;

With a printer, the report will be printed automatically after the cleaning procedure is completed;

Equipped with 40L liquid storage tank, programmed to automatically inject during closed-loop cleaning;

When using environmentally friendly cleaning solvents for open-loop cleaning, only 0.045L per cycle;

In open-loop cleaning, the liquid after cleaning with an environmentally friendly solvent can be directly discharged after being filtered by a filter, which meets the environmental protection discharge standard;